Master Cylinder install question
#1
Master Cylinder install question
Hey all,
I pulled out my old MC for the disc conversion I'm doing. It was kind of a pain to get that cotter pin that was holding the pedal, loose. When I go to put the new MC in, I'm trying to figure out how in the heck and am I going to get that pin back in there. I was thinking I could remove the steering column, but I'm not sure if that is something I want to do. Anyone have any suggestions? thanks
I pulled out my old MC for the disc conversion I'm doing. It was kind of a pain to get that cotter pin that was holding the pedal, loose. When I go to put the new MC in, I'm trying to figure out how in the heck and am I going to get that pin back in there. I was thinking I could remove the steering column, but I'm not sure if that is something I want to do. Anyone have any suggestions? thanks
#2
RE: Master Cylinder install question
Not trying to be a wise-a_s but it goes in just like it came out. Take a pair of needle nose pliers and hold the clip once in the hole push her home. It's not necessary to pull that column down.
Thread
Thread Starter
Forum
Replies
Last Post
Faolan65
New Member Area
2
08-27-2015 06:40 AM
Faolan65
Arizona Regional Chapter
0
08-25-2015 09:24 AM
Figure8allday
4.6L (1996-2004 Modular) Mustang
6
08-22-2015 11:11 AM