YES!! Extremely....If you get one, don't glue or tape it in. Just set it in so you can remove it.

Mike

 

Definitely does. The most forward cupholder (closest to the stick) becomes almost useless and won't even fit a skinny bottle of water, whereas the back holder narrows to the size of what the front holder used to be. You basically lose one cup holder. But you know what? I was only using one of them before I bought it anyway, because the back stock cupholder is TOO BIG. I used to only use the forward holder, and now that I've lost that one and the back one is now stock size, I use the back one for my coffee and the front one for my cell phone, gum, etc. Still, it's fantastic piece - amazing triple chrome quality.

 

You can not drink & drive in WA, so I don't. The cup holder ring looks SWEET !!

 

LOL i think that law is refering to alcohol...i'm pretty sure drinking coke while driving is still legal.

 

Um no., look it up !! Drinking and driving in WA is illegal. Also had friend get pulled over for drinking coke...........

There is lots of laws most people are not aware of, like amplify your exhaust:

(3) No person shall modify the exhaust system of a motor vehicle in a manner which will amplify or increase the noise emitted by the engine of such vehicle above that emitted by the muffler originally installed on the vehicle, and it shall be unlawful for any person to operate a motor vehicle not equipped as required by this subsection, or which has been amplified as prohibited by this subsection. A court may dismiss an infraction notice for a violation of this subsection if there is reasonable grounds to believe that the vehicle was not operated in violation of this subsection.


The new law in a nutshell, you cant have a modified exhaust that is any louder than stock.

 

for what it's worth I just received my billet window switch bezels from Mustang tuning (American Muscle) that I had ordered way back in JUNE! So maybe they just stopped shipping until the name change?
They are a little too shiny than they seemed in the photos but I'll give em a try.

 

I did and it fits over the existing E-brake handle and has a hex nut on the lower side of the handle that holds it in place! It is a very snug fit even without the hex nut