TRUNK BLACK OUT PANEL
#21
RE: TRUNK BLACK OUT PANEL
Hey Pete,
Yes, my blackout panel is the one from Moss Mustang. The bezels are from Moss as well, right here.
http://www.mossmustang.com/Shop/View...eIndexID=48642
Mike
Yes, my blackout panel is the one from Moss Mustang. The bezels are from Moss as well, right here.
http://www.mossmustang.com/Shop/View...eIndexID=48642
Mike
#24
RE: TRUNK BLACK OUT PANEL
I just got a flat black vinyl black out panel and i think it looks very good. I think i got it from moss but i really did not pay that much attention. My family runs a dealership and the way they put it on was very good.
1. Wash the back of the car.
2. spray back with a soap/water mixture - the mixture doesnt hurt the adhesice but lets you have a few hours to get it just right.
3. align it properly
4. using something firm and flat, gently push out the air bubbles. This may take up to an hour. Push some and take a break, then come back and flatten some more.
5. The edges can be folded/cut after the piece has been put in place.
6. Let sit overnight to finish adhering.
Here is a pict of mine shortly after it finished.
[align=left] [/align]
[IMG]local://upfiles/54412/315A903BA76C46AC8E8E783E64DD9B4C.jpg[/IMG]
1. Wash the back of the car.
2. spray back with a soap/water mixture - the mixture doesnt hurt the adhesice but lets you have a few hours to get it just right.
3. align it properly
4. using something firm and flat, gently push out the air bubbles. This may take up to an hour. Push some and take a break, then come back and flatten some more.
5. The edges can be folded/cut after the piece has been put in place.
6. Let sit overnight to finish adhering.
Here is a pict of mine shortly after it finished.
[align=left] [/align]
[IMG]local://upfiles/54412/315A903BA76C46AC8E8E783E64DD9B4C.jpg[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post