Spoiler delete
#12
the bolts were about 4 inches in length, and the top was about 1/2 inch in diameter. just make sure you get ones that have a smooth top, some have numbers stamped in them.
then i cut the bolt just below the nut with a Dremel.
something like this:
then i cut the bolt just below the nut with a Dremel.
something like this:
#13
id say, tape the bottom side of the hole with duct tape/something really strong, then mix up some bondo, and pack it in the hole.... get it nice and flush, sand it... then hit it with touch up paint, you shouldn't really see a big difference. i think it looks a little better than a bolt head hanging out....smooth or not.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
0
10-01-2015 08:58 AM
Boostaddict
3.7L V6 S550 Tech 2015 - 2017
0
10-01-2015 08:57 AM