07BLACKGT

Oh wow sorry I didnt read the whole post. Thats awesome! It actually goes in where the license plate goes! I've been looking for some that aren't painted that will go inside there! Thanks!

4LITER6

I like it........................

Warhead711

It's all pieced together by hand and not a kit. If there is a kit that will do this I am not aware of it (I am not a hardcore enthusiast like many here). For example, when I filled in the FRONT license plate holder last night, I had to cut 3 pieces for each stripe to run through there.

The first piece was to fill from the top of where it curves down, to the bottom where it flattens out for several inches.

The second piece was largely to fill in the flat center part which filled it out to the bottom.

The third piece was a small piece that filled in the side portion that slants in (similar to the first piece).

I had also cut around the mounting / screw holes as well to avoid bubbling later.

You have to get right up on it to see how it was done, it very much looks painted from all but the closest looks.

Warren

omer333

looks really good man.

y'know, i think the white drop top looks a lot better than the black tops.

Diabolical!

The white top looks excellent. I'm not digging the way the front bumper stripes were installed though.

Rdot9

nice, the white top looks really nice with your car

MantaDreams

looks great! there is a convertible forum, but its not very active.

this subforum also talks about appearance, and readers are not shy about giving their opinions when asked, and sometime when not even asked.

GidyupGo

Not a huge fan. IMO, the white only looks OK on a red car. I would have stayed with the black top. I also like the tan top on a red car. The white top "matches" the stripes, but it takes away from them. Too much white!

oshkoshbajawsh

get some white bullitts and that would be one of my favorite looking 6's on here

28HopUp

That new top looks sharp [and I don't mean that as in it will put your eye out!]