FUBAR'D my SCT XCAL.....I think
#1
FUBAR'D my SCT XCAL.....I think
Well got an email tune from Brenspeed, all pumped up to install my CMCV's I purchased from a guy on this forum tomorrow, and I go to upload the tune to my Tuner..........says wrong serial number, so I figure heck must be becasue all the slots are full on the thing, so I hit erase, but i chicken out when the prompt comes up to ok.....I thien hit the X to close it out figureing it would cancell the operation................well it didn't it wiped my tunes (not formatted) and I still could not upload the email tune from brenspeed.
So I'm worried what the diagnosis will be tomorrow or today when I call them.
So I'm worried what the diagnosis will be tomorrow or today when I call them.
#3
RE: FUBAR'D my SCT XCAL.....I think
Or just have Brenspeed send you all the tunes again, and let him know what your serial number is if need be? I've loaded about two tunes brent has e-mailed me and never had a problem with either. You did DL all the driver's and software from SCT's site?
#4
RE: FUBAR'D my SCT XCAL.....I think
Yes I DL'd all the Drivers and Live Load 3 just as my email stated. Seth @ Brenspeed is fixing it now, I think there was a number transposed or lost in translation over the phone when I called my order in.
I learned also that I don't need all the tunes in my xcal just the one I'm using, so he is sending me the updated 93 delete plate tune and we'll see where we stand
I learned also that I don't need all the tunes in my xcal just the one I'm using, so he is sending me the updated 93 delete plate tune and we'll see where we stand
Thread
Thread Starter
Forum
Replies
Last Post