ok well im adding an aftermarket sub to my factory shaker 500 system, first question where did you guys tap your remote wire into? also i was wanting to get my signal from the factory amp as i figured it would be best for this setup, but where in the amp at? where did you guys get your signal from for the sound, i dont really want to get it from the rear speakers either

 

Well its not the cheepest way to do it but it the easy way for sure http://www.stage3motorsports.com/pro...Clearance.html And check out the wiring diagram on that page it mite help you too.

 

http://iihs.net/fsm/?dir=40&viewfile...Navigation.pdf

 

tn_gt, just out of curiosity which system are you getting, as i know JL, MTX, and RF all make custom setup.

 

well i finally found a place that showed what i was looking for, but i didnt realize it would be so hard to find a source for the remote wire, like in all honesty it was ridiculous

 

take pics im looking at doing the same thing

 

ok i got it finished, i tapped my source wire from the input wire into the factory amp, and had to get my remote wire from my ambient lighting setup lol, ill post pics tomorrow...i screwed the amp into the trunk between the back speakers (looks killer) it was overall a simple install once i knew where to get the source/remote from