Edelbrock E-Force SC Kit Dyno Results!
#25
Well, I went to JDM today to hang out for a bit. To my surprise my car was put on the dyno and was tapped by a professional, and you should see it soon on youtube and a number of different places!!!! JDM Sr came on and even explained on whats going on and talked about the tune some.
It was pretty much the same as before, but it was shown SAE corrected.
Now JDMs turn...to tweak a few things
Sr managed to change a few things on the tune, but nothing too aggressive due to the fact I have a stock fuel pump, and smaller injectors. However we managed to get the following:
HP 434.54
TQ 417.08
It was corrected 1.05 since it was nearly 100 degrees in the bay at the time. A very nice pull however...
Here is the video of one of the runs (watch in HQ, and it maybe still processing...) and the dyno graph (before and after):
http://www.youtube.com/watch?v=nOf2bRgLdok
It was pretty much the same as before, but it was shown SAE corrected.
Now JDMs turn...to tweak a few things
Sr managed to change a few things on the tune, but nothing too aggressive due to the fact I have a stock fuel pump, and smaller injectors. However we managed to get the following:
HP 434.54
TQ 417.08
It was corrected 1.05 since it was nearly 100 degrees in the bay at the time. A very nice pull however...
Here is the video of one of the runs (watch in HQ, and it maybe still processing...) and the dyno graph (before and after):
http://www.youtube.com/watch?v=nOf2bRgLdok
#26
This was the video that was made by the professional (with the Edelbrock tune):
http://www.youtube.com/watch?v=wFOCpufFp9U
http://www.youtube.com/watch?v=wFOCpufFp9U
#28
If the weather is nice I can do a inside cabin clip tomorrow and hopefully it should give you a good idea. Right now the car is resting since it did nearly 9 dyno runs, and then one really nice road test which included Sr doing a nice burn out :P
For all those that are running, NT555 are pretty sticky tires... My back bumper can agree to that :P
Last edited by Smooth_J; 05-10-2009 at 10:13 AM.