Pypes fitment and products.
01-31-2010, 05:53 PM
#1
3rd Gear Member
Thread Starter
Join Date: Sep 2009
Location: Idaho
Posts: 829
Pypes fitment and products.
Okay well I ordered my third pypes product. A set of violators with over axle pipes.
I have just been reading reviews and may just sell these when I get them instead of dealing with more fitment issues from pypes.
And Im curious has anyone ever installed these WITHOUT any issues? And had any luck with them lining up straight? Is there any hope for these mufflers fitting right or should I just sell them new?
I have just been reading reviews and may just sell these when I get them instead of dealing with more fitment issues from pypes.
And Im curious has anyone ever installed these WITHOUT any issues? And had any luck with them lining up straight? Is there any hope for these mufflers fitting right or should I just sell them new?
01-31-2010, 06:17 PM
#3
1st Gear Member
Join Date: Jan 2010
Location: Kentucky
Posts: 132
I installed the axle backs on my car with no problems. They are made in China though so quality control might not be spot on with every set. This is part of the reason Pypes products are so much less expensive than the American made exhaust products.
01-31-2010, 06:34 PM
#5
S197 Section Modder-ator
Join Date: Sep 2007
Location: Orlando FL
Posts: 13,373
Pypes are usually approximate in fit, despite some people having good luck with them.
Their clamps are junk though and need expert tweaking for a leak free installation.
I much rather go to a good muffler shop...
Their clamps are junk though and need expert tweaking for a leak free installation.
I much rather go to a good muffler shop...
01-31-2010, 06:51 PM
#8
2nd Gear Member
Join Date: Jan 2010
Location: Atlanta
Posts: 343
