Brenspeed installed special grind SC Comp Cams this spring, and I finally decided to have it dyno'd today. 451 rwhp and 406 tq.

It was 80-85 degrees, used ice to cool down the SuperShaker after the drive over and before the pull.

 

how much boost
what was the before numbers

 

8 to 8.5 I think.... As much as I like my Interceptor gauges, the boost has a formula that not sure is real accurate. I have a 3.4 pulley.

My previous best was 398 rwhp, was a really hot day and car was hot, really affected the timing I think.

Between that run and this one the cams, KB BAP, HTO plugs, and change from stock pulley to the 3.4.

 

any vids of the cams in action w/super shaker?

 

^^ yes Yes YES!!!!! We want to hear that baby!

 

Might ask your dyno for a readout on the boost as they should be measuring that during the runs.

 

congrats Toy4Bob, nice numbers

 

Well, I actually don't think I have a good idle vid, but here are a dyno from last fall and a drag with a friend from last summer to hold you over.

I will try to make an idle vid tomorrow, but making a trip to my kids college so will be a busy day

Vids:

http://www.youtube.com/watch?v=NjCxXgm6G-4

http://www.youtube.com/watch?v=nTkdK...eature=channel
He bought the beers that night!

 

Brent made a comment about not knowing if I had a boost gauge (my interceptor gauges were unplugged since he had my X3 plugged in, so he didn't see that was one of my settings), and didn't mention anything about knowing what my boost was other than pulley size.