Just put new rims and sensors on my 2010 and got the sync tool from American Muscle and i can only get the left side wheels to set. Anyone have any tips or problems like this? Set pressure perfect to 32 in all wheels and tried with the stems and different positions and still no luck. Should i try the dealer to see if they have luck or just take the hole in my wallet for trying to do something right and putting them in to start.

 

Depending on the wheel/tire combo you chose maybe needs more air? Worth a try. I just remembered when I took off my summer wheels and put the stock wheels back on I had to drive a little before the dash light went off

 

might give that a go im up for anything that might work at this point but the drivers side sensors cal but nothing at all from the right side and they have the same psi

 

Maybe you took to long to get the other side after putting the car in learn mode??? Do the valve stems need to be in a certain position close to the sensors? The dealer where I bought my car used their tool to teach my car the new 18" wheel sensors when I put them on. Free. Took the service writer about 2 minutes to do it. Less time that writing it up would have. I was there for a service anyway though.