I had my first dyno experience today. I know its just numbers and all that fun stuff, but I really thought I would have shown more than 275hp.


It was on a Mustang Dyno and the guys seemed to be on point and knew what they were doing when putting in the parameters (weight, weather,etc).


Am I wrong to think it should have been in the 290-300 range or is 275 more in line with what my car is modded with??

The first pull was 240 something and I was like, no way that is right, second was 252, and the third after we let it sit for 10 minutes came out to 275.

I should have the dynograph at some point today and I will load up once I get it.

 

My first pull was 275 4 years ago with Corsa installed only, no tune, no CAI, no other mods.
with all the mods you have, 275-280 might be right for auto.

 

There is that much of a difference between an auto and a manual??

275 with exhaust only is what you got and I pulled that with CAI, 93 tune, UDP, CMDP.....

 

The age of the car may affect the result. I didn't my first pull 5 months after I bought my car brand new. My current pull last month is 322rwhp with all the mods done..

The lowest auto dyno pull I have seen is posted on livernois motor sport, and it is a

2005 Mustang GT Auto - Stock Baseline - 239 RWHP / 255 RWTQ

 

don't read so much into it. a dyno is a tuning tool, it's not an ultimate measure of power, and no two dynos are created equal. mustang dynos typically read lower then dynapaks or dynojets, too.

 

That sounds about right on a Mustang Dyno I would say.

 

 

My was low on a mustang dyno too check sig,