Roush Front Fascia w/grill Fog delete
#91
From the Roush website. But I only looked to get the order PN and then went to my dealer (Roush Authorized dealer) to get the parts. The list the upper and lower grille
#92
Thanks Wilkinda... I checked it out & it turns out they only offer the lower grilles for 2010+ (mine's a 2006 Roush). I just put the 9-bar grille on it today, but I guess I'll leave the lower air dam open - looks fine.
I'm going to add pinstripes along the outer edge of the stripes in the pics, it's almost done other than that last detail.
I'm going to add pinstripes along the outer edge of the stripes in the pics, it's almost done other than that last detail.
#94
Well, the Roush wire harness extensions came in.... These were obviously not the correct extensions for the job. They were only 6" long. They were obviously made for extending the OEM fogs to the center position of the grille. Therefore I played Frankenstein and created my own from the harness that came with the foglight kit (this harness would not work with the OEM switch for the fogs and required adding new switch some where in the car.... I DON'T THNINK SO!!!
So now my harness is made and I verfied it works. Now to add wire wrap to it and put the front end on!!!
Pics will be added when I am completed......
So now my harness is made and I verfied it works. Now to add wire wrap to it and put the front end on!!!
Pics will be added when I am completed......
#96
That's what I did on mine. All I did was use the roush harness and made an extension that plugged into the factory plugs. Just took a couple cuts and solders to make since the roush harness plugs into the stock line and basically makes a split into two outlets. I just removed one of the outlets and cleaned it up a bit. Worked great and looks factory :-)
Thread
Thread Starter
Forum
Replies
Last Post
Galactic
Archive - Mustangs For Sale
10
04-29-2019 02:56 PM