So while I was in Vegas for a couple days, Brent over at RockyMountainGraphics.com mocked up a matte super snake stripe for me. Ended up being a 16 inch wide center with one inch space and then one inch pin stripes. Its about to rain this afternoon, so this is the teaser pic till tomorrow afternoon. It looks damn good with my center fog grille. Pics tomorrow will also show my new chin spoiler and side splitters installed. Now I just need to order my CC plates to install my Strano sourced suspension.




UPDATE: Better pics just taken. Camera is poopy point and shoot and car isnt as clean as I like since It was driven back and forth to work today. I will take pics with better lighting after I install my suspension. Second to the last pic kinda makes it look crooked a bit, but its dead straight. Pics include the recent additions of CDC chin spoiler, side splitters, and my new plate frame in the back. Its a quote from Mad Max in Road Warrior. Im slowly building a car that I think would be the nowadays equivelant of Max's Black V8 (my favorite movies are the Mad Max films)

 

looks good

 

^second that looks damn good sir can't wait to see chin&splitter install pics how low is the drop going to be?

 

Its Sam's Handling Package #1. Steeda Sport springs with Koni STR.Ts. So it should be 1 inch in front and 1 1/4 out back. Might be a little higher at first and need to settle. I should be ordering those plates sometime this week. I need to get over the financial kick in the junk that is Las Vegas first haha.

 

Those look gorgeous...I've been thinking of getting the same thing. How much did those run you?

 

You did great.....that's my favorite color stripe on a black mustang.

 

Not sure how much he will sell kits for. He has used my car for a mock up a couple times so we made an agreement.

 

i like!

 

Same, nice and subtle.

 

you did good, that is my favorite color & type of stripe....if I didn't have a clear bra on my front end, it'd be on!