Thought I'd do a little something different than everyone else. Here is how it came out.

 

It is different, I'll give you that. Expect lots of questions!

 

Looks pretty nice, any wide shots of your car?

 

Yeah... let me go do that. ...Was hoping to remove the Pony emblem on the front quarter panel before I did. Haven't been able to find if it's just held on by adhesive, or if its pinned on.

 

I believe those are pinned on. You gonna hold on to them? I'd take them off your hands if you don't want them

 

Yikes... I sure hope they aren't pinned on. I knew earlier generations were, but still trying to find a definate answer. Will be wanting to get rid of them if they are just the adhesive type.

 

Here you go. Apologies in advance for the terribly flat lighting, and my utter inability to take a good picture.

 

They are pinned on, I was gonna take them off too, until I realized they were...

 

They are NOT pinned on. They're held on with double sided 3m tape, but do have two alignment holes that the stems on the back fit into. Those are there for alignment only, no pins holding them in, just the tape.

 

/\/\

Correct. Take em off though and have two small holes there.

I went from GT badges to the V6 emblems as I liked them better. lol

If you DO remove them, use some thin fishing line in a seasaw motion gently until you cut thru most of the adhesive, then pop em out. Just be patient and can get em no problem.