New to the mustang world. I am using the 2011 3.7 V6 engine, and a dogbox out of a corvette track car.

Is it possible to get these two to mate? Been calling around, and supposedly ford isnt even showing a part number for the 3.7L Bellhousing. And a few of the custom bellhousing manufacturers are in the R&D phase of the 3.7

Any suggestions?

 

Well the bell housing on the MT-82 does not separate from the body, so it will not have a part number. I am working with Tremec on a T-56 install and Bruce at Modern Driveline is working on a custom bell housing for this kit. I can tell you the housing bolts are 10mm X 25mm with a 1.5mm thread pitch. Most likely you are going to look at a one off bell housing.