power limit?!??!?!
#11
RE: power limit?!??!?!
yeha i have a 5 speed.. and my dads friend who has 2 vipers with twin turbos that runs i think 8's or so and did everythign from putting them on and everything else in between said that he could pull the engine and do anything i wanted for free just have to buy the parts myself of course.. but i dotn have to worry about the labor fee ya know.. so just the parts a lone are a lot of money im guessin?
#12
RE: power limit?!??!?!
rods 500-600$
pistons 500-600$
forgot you already had the forged crank because of the manual.
Gasket set ????
If you have low miles I would skip the machining and just hone the cylinders yourself and leave the factory holes stock size. Save money and will last just as good.
pistons 500-600$
forgot you already had the forged crank because of the manual.
Gasket set ????
If you have low miles I would skip the machining and just hone the cylinders yourself and leave the factory holes stock size. Save money and will last just as good.
Thread
Thread Starter
Forum
Replies
Last Post
KingRando
2005-2014 Mustangs
5
10-02-2015 08:06 AM
treesloth
New Member Area
4
09-28-2015 07:03 AM
MustangForums Editor
General Tech
0
09-25-2015 06:58 PM