Service Engine Soon P1451
#2
RE: Service Engine Soon P1451
I did a little research on the internet, found that P1451 means barometric pressure sensor performance.
WTF is a barometric pressure sensor? Where is it, and how do you replace it?
WTF is a barometric pressure sensor? Where is it, and how do you replace it?
#3
RE: Service Engine Soon P1451
what year is your car side.....? If it's a 2000 then good luck with those suckers...Man my check engine light stayed on...I could never figure it out and i think the dealership had no clue as to what was wrong with it.
#4
RE: Service Engine Soon P1451
It's a '99. I ran it past the parts guy at the dealer because I wasn't sure what that sensor is. He said that car doesn't use one, it's part of the MAF. He said that was probably bad.
#5
RE: Service Engine Soon P1451
I work at FORD and have never heard of a p1451 on a pony. So i did alittle research. P1451 has to do with the CV on the Emmisions. Control valve for the Charcoal canister. I look into it and write back tomorrow
#8
RE: Service Engine Soon P1451
P1451 - EVAP Control System Canister Vent Solenoid Circuit Malfunction. Thats what FORD says the code is for. Like i said before i have never seen this, but one of the main problems is corrosion getting into the connecter and causing problems. You could also clear the code and then see what happens
#9
RE: Service Engine Soon P1451
OKay, now where is that? I looked under the hood, there is a black canister up against the firewall on the passenger side with a black steel tube going to it, and 2 other tubes coming out. There is also a connector on the top of it. Is this what you're talking about?
#10
RE: Service Engine Soon P1451
I'm still having this problem if anyone else has any ideas. Casper...Thanks for your help. I cleaned the connector you were talking about, and it didn't seem to do anything. I've cleared the code 10 times, but now it just comes right back on.
I'm going to have this MF'er cubed if I don't come up with any solutions!!
I'm going to have this MF'er cubed if I don't come up with any solutions!!