CLUTCH install --- new clutch new clutch
#23
RE: CLUTCH install --- new clutch new clutch
how long does it grind for? does it sound like a bad bearing or a gear on gear clash??
is the starter new? what did you do to it?
I reused my old one but I 'rebuilt' it, as in tore it down, cleaned it, and lightly greased all the bearings and it works nice now
is the starter new? what did you do to it?
I reused my old one but I 'rebuilt' it, as in tore it down, cleaned it, and lightly greased all the bearings and it works nice now
#24
RE: CLUTCH install --- new clutch new clutch
It just grinds.. but not even a grind really... a squeal actually. Just will the key is turned over once the car starts everything is fine.. The starter was working great before the clutch and all was replaced..
#26
RE: CLUTCH install --- new clutch new clutch
so when you are cranking it makes a hideous noise? These starters are NON adjustable... I'd suggest (unfortunately) taking it off and having a look see at it. While I had mine out i rebuilt it and cleaned everything and lubed it...
I think u need a starter unfortunately
I think u need a starter unfortunately
#27
RE: CLUTCH install --- new clutch new clutch
I really dont think I need a new starter.. Just doesnt make sense that it works completely fine, no problems out of it then it goes back on and all of a sudden i have trouble.. I cant remember if i can get to the starter without pulling the tranny or dropping the mid-pipe??? I didnt get under it tonight but i will for sure tommorrow after i get done with a funeral..
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM