I've got another snag...
#1
I've got another snag...
The ground wire that connects to the block on the drivers side of my motor is rusted to the bolt. I can loosen and begin to turn the bolt but the wire turns with it.I tried hammering it off with a screwdriver but its really hard to get at.
I dont want to crank it and have the wire pull out of the wiring harness. That would suck. If Ijust cut the wire near the bolt then spliced and soldered it back together when Im ready to reinstall would that work ok?
I really dont want to start hacking wires, but I dont know how else to get this off.
I dont want to crank it and have the wire pull out of the wiring harness. That would suck. If Ijust cut the wire near the bolt then spliced and soldered it back together when Im ready to reinstall would that work ok?
I really dont want to start hacking wires, but I dont know how else to get this off.
#4
RE: I've got another snag...
i don't see any problem with doing that
ORIGINAL: Mark99GT
The ground wire that connects to the block on the drivers side of my motor is rusted to the bolt. I can loosen and begin to turn the bolt but the wire turns with it.I tried hammering it off with a screwdriver but its really hard to get at.
I dont want to crank it and have the wire pull out of the wiring harness. That would suck. If Ijust cut the wire near the bolt then spliced and soldered it back together when Im ready to reinstall would that work ok?
I really dont want to start hacking wires, but I dont know how else to get this off.
The ground wire that connects to the block on the drivers side of my motor is rusted to the bolt. I can loosen and begin to turn the bolt but the wire turns with it.I tried hammering it off with a screwdriver but its really hard to get at.
I dont want to crank it and have the wire pull out of the wiring harness. That would suck. If Ijust cut the wire near the bolt then spliced and soldered it back together when Im ready to reinstall would that work ok?
I really dont want to start hacking wires, but I dont know how else to get this off.
Thread
Thread Starter
Forum
Replies
Last Post
BigDinTexas
5.0L V8 Technical Discussions
27
08-23-2012 08:34 PM