02WinDixieGT

Ijust rebuilt a 96 4.6 out of a crown vic. and used the heads and cams from a 2004 Mustang GT and intake manifold and things from a 2002 GT and was wondering where i can find a diagram or good detailed pictures on how to hookup the vaccume hoses and electrical plugs.. ive got everything i know but still have a few left over i can find where they go...didnt know if there were left over plugs for add ons or anything like that, i didnt break the motor down myself so i didnt have the luctury of labeling things, thanks guys!!!

oxfordgt

Check out my "how to build you own engine" thread at the top of this section. I put a wireing harness lay out in it and the vacum lines only reach where they go.

02WinDixieGT

Appreciate it!!! Most of it has been simple and straight foward and pluged right in no question, but towards the end of the wireing harnesses there a few plugs and one or two in the beggining, but thanks again

02WinDixieGT

what about the tubes off of the plenum and intake? i have those hooked up but i want to make sure in the right place, thanks!!

02WinDixieGT

TTT....Anyone have any detailed pictures of a 2002 or similar engine showing these hoses? Thanks

Mark99GT

Totally unrelated to theop, but what kind of wheels do you have? Sorry I don't have a diagram. I had the same problem last month. If you look at it long enough you'll figure it out.

02WinDixieGT

XP Prostars 17"