HELP -I BROKE OFF IN MY 96 GT ANY HELP
#2
RE: HELP -I BROKE OFF IN MY 96 GT ANY HELP
well, a lock smith would be a good idea, especiallyif you have AAA, otherwise make one piece of the key into an electromagnet and then pull the other end out. Hopefully it's loose enough to slide out easily.
http://www.energyquest.ca.gov/projec...tromagnet.html
http://www.energyquest.ca.gov/projec...tromagnet.html
#6
RE: HELP -I BROKE OFF IN MY 96 GT ANY HELP
ORIGINAL: livefast1
drill a small hole in it, put some jb weld on the end of a paper clip and slip it in and let it sit, then pull out.
drill a small hole in it, put some jb weld on the end of a paper clip and slip it in and let it sit, then pull out.
I would only suggest this if you have insanely steady hands. It can be done, but if you miss the hole...
Crazy glue on the tip of a paperclip- even if you can only get it out a little, it will be enough to use something else like tweezers.
#7
RE: HELP -I BROKE OFF IN MY 96 GT ANY HELP
use two of your mommies bobby pins. straighten htem out then put a little 90 deg bend about 1/32 and inch back. use them like chopsticks. I know this works. Lets not get into HOW I know it works....
#8
RE: HELP -I BROKE OFF IN MY 96 GT ANY HELP
I am curious, how did the metal of the key break off exactly so you cannot pull it out of the ignition?
I could understand breaking off the plastic chip piece of the key, but there is still metal embedded inside it, and that would be enough to get a grip to pull it out...
I could understand breaking off the plastic chip piece of the key, but there is still metal embedded inside it, and that would be enough to get a grip to pull it out...
Thread
Thread Starter
Forum
Replies
Last Post
CMcNam
4.6L V8 Technical Discussions
17
10-30-2022 11:40 PM
stangin1996gt
4.6L (1996-2004 Modular) Mustang
0
09-21-2015 11:01 AM