jml317

i have a 03 gt, and the throw out bearing went out so im trying to cange it got all bolts out of trans starter off shufter removed etc... i can not get the tranny out though it wont budge have tried jacking it up and down tried pulling it back with a rachet stripe also normal just shaking it lose. any sugestions?

sv650lex

Double check again to make sure all the bolts are out then try prying the bell housing from the block. Be carefull not to crack anything. A lot of people will advise against this but it's what I had to do also.

JC316

9 times out of 10, you missed a bolt. I think there are two at the top, three down the drivers side and three down the passenger side.