Some stuff to think about!
#11
RE: Some stuff to think about!
A CNC machine is used to CNC the heads, what it does is make the head flow exaclty the same in all aspects of the ports and chambers. If you dont have a CNC machine you can port by hand and use a flow bench to test your work..............esciencialy the same thing as CNC only a poor mans version. Now Code3 please dont try to bring me down, I am pumped up about my non pi project and am raising a little hell in my wake! Believe me I have built blown bigblocks with about 1200+hp enough to damn near suck the sheet rock of the dyno walls.........So please just bare with me!
#12
RE: Some stuff to think about!
ORIGINAL: yoteehunter
A CNC machine is used to CNC the heads, what it does is make the head flow exaclty the same in all aspects of the ports and chambers. If you dont have a CNC machine you can port by hand and use a flow bench to test your work..............esciencialy the same thing as CNC only a poor mans version. Now Code3 please dont try to bring me down, I am pumped up about my non pi project and am raising a little hell in my wake! Believe me I have built blown bigblocks with about 1200+hp enough to damn near suck the sheet rock of the dyno walls.........So please just bare with me!
A CNC machine is used to CNC the heads, what it does is make the head flow exaclty the same in all aspects of the ports and chambers. If you dont have a CNC machine you can port by hand and use a flow bench to test your work..............esciencialy the same thing as CNC only a poor mans version. Now Code3 please dont try to bring me down, I am pumped up about my non pi project and am raising a little hell in my wake! Believe me I have built blown bigblocks with about 1200+hp enough to damn near suck the sheet rock of the dyno walls.........So please just bare with me!
Thread
Thread Starter
Forum
Replies
Last Post