cold start problems
#1
cold start problems
newbi here....its gotten down in the teens here in texas for the past couple of days. i havent driven my car in over 24 hrs and just now i ran down the street to grab some food. my car took a bit to warm up, understandable right, but would not stay running in neutral, even after the engine was warm. the rpms would drop so low and it would just die. the entire trip was no more than 25 minutes and it would not tay at an idle. help please
comp cams, accufab throttlebody, c&l intake, sct tune
comp cams, accufab throttlebody, c&l intake, sct tune
#4
RE: cold start problems
Yea I would like to know how I would go about cleaning it also.. And where its located?
Because my car takes about 3-4 clicks before it starts when its cold out.. and that can't be very good.
Because my car takes about 3-4 clicks before it starts when its cold out.. and that can't be very good.
#5
RE: cold start problems
Actually its on the plenum. Has 2 5/16screws on it with a hose that goes to the CAI. Take it off and spray it with some carb/ fuel injector cleaner real good and re install it and it should be fine.
Thread
Thread Starter
Forum
Replies
Last Post
ShaneB26154
4.6L (1996-2004 Modular) Mustang
35
03-04-2021 04:05 AM
HIS S-197
4.0L V6 Technical Discussions
1
08-10-2015 05:47 PM