I think I will see 12's.
#13
RE: I think I will see 12's.
^Yeah true 98,
I went with a 3k instead.
Only other high stall vehicle I have drove was my 3200 stall'd s-10 with a 408sbc in it.
and on the street yeah it was fine, from a light it would just be like normal when I would take off it would accelerate at around 1,700 etc... like normal- didn't hurt my mileage that I noticed either (but then again I do not pay that much attention to gas mileage)
...but of course if I stomp'd on it of course then it would stall up.
So yes I am going with a 3k and that will probably launch me at about 2600 or so before I start to turn over the tires, you think?
If I can launch at 2600 I will be happy.
and Yes .4-.5 is NICE! that is what I hope I can take off. with about +2 mph in trap speed.
this should help me out all through out the 1/4 mile- launch, traps, and of course overall Time.
Demon I am installing my stall as soon as its done being built.
which should be after this weekend... (monday)
then I will make quite a few runs and trips to the track until I feel that is the lowest I can get the car.
I will post up times..
then I will add my headers,mid,catback. and see what times I run.
Yeah I have chose all my mods very wise and seems to being paying off nicely.
Thanks fellas!
I went with a 3k instead.
Only other high stall vehicle I have drove was my 3200 stall'd s-10 with a 408sbc in it.
and on the street yeah it was fine, from a light it would just be like normal when I would take off it would accelerate at around 1,700 etc... like normal- didn't hurt my mileage that I noticed either (but then again I do not pay that much attention to gas mileage)
...but of course if I stomp'd on it of course then it would stall up.
So yes I am going with a 3k and that will probably launch me at about 2600 or so before I start to turn over the tires, you think?
If I can launch at 2600 I will be happy.
and Yes .4-.5 is NICE! that is what I hope I can take off. with about +2 mph in trap speed.
this should help me out all through out the 1/4 mile- launch, traps, and of course overall Time.
Demon I am installing my stall as soon as its done being built.
which should be after this weekend... (monday)
then I will make quite a few runs and trips to the track until I feel that is the lowest I can get the car.
I will post up times..
then I will add my headers,mid,catback. and see what times I run.
Yeah I have chose all my mods very wise and seems to being paying off nicely.
Thanks fellas!
#14
RE: I think I will see 12's.
Ah yes, I forgot. I gained around half a second in the 1/8, but I also added LT headers/off road x pipe. So yea, you'll definately be happy!
I figure you'll at least be able to launch around 2500. Precision Industries told me it just depended on your power level as to what the stall will actually stall to. I could only launch around 2k-2200, but I only ran Nitto's. With your BFG's, you might be better off just flashing the stall off the line and hoping it dead hooks....it has a good chance to.
I figure you'll at least be able to launch around 2500. Precision Industries told me it just depended on your power level as to what the stall will actually stall to. I could only launch around 2k-2200, but I only ran Nitto's. With your BFG's, you might be better off just flashing the stall off the line and hoping it dead hooks....it has a good chance to.