I know its not that difficult.. but is there anything I should know about before the install? How long does it take? Im pretty mechanically inclined..Ive changed heads on an LT1. But thats a bit different Thanks!!

 

Just be careful removing the TPS screws. They are locktited in and you can bugger the screw heads pretty easily. Take your time and you'll be OK[8D]

 

Yeah its not bad,just take your time and your be fine.It takes hour or so to slap them on.

 

Yea I think I saw someone mention that in a thread before now that you say that. Thanks for the heads up man!

 

Other than that, just remember where everything goes! I'm not mechanically inclined at all and the entire install took 45 minutes.

 

Ya my dad taught me alittletrick to label everything with A,B,C, etc so I don't lose track Thats good to know it only took you 45 min cause its effing freezing here in CO!

 

you will have to watch the throttle body when installing the end of the throttle cable you may need to get a piece of sand paper and sand down the piece at the end of the cable to fit into the throttle body fitting(it can be very snug) and it will be a lot easier to install. i had to do this with my BBK...........

 

It was a little snug with my car, but nothing a little muscle couldn't fix

 

everything is a simple swap just becareful with the tps screw like the others are mentioning

takes probably 45mins to an hour for ya

 

haha yeah damn those tps screws!!!!! its an ez install shouldnt have n e probs tho