Sxynerd

This is what I was doing tonight. I think I'm going to clean up the inside a little better but I don't think it could have turned out any better. AND I DIDN"T HAVE TO SPEND 80 (after shipping) FOR MMR's ADAPTER PLATE.

I have $18 into this plate. (cost of the metal)

mustangman281

Looks good. Clean up the inside some more and make sure the mating surfaces are flat.

Since you have the grinder out slap on the intake gaskets and port match the intake.

Sxynerd

SVTeeshirt

damn looks good, **** your money havin ***! lol. Whens the E.T.A for the whole thing to be finished?

Sxynerd

Everything should be done today, except tuning. (but I have also said that several times before and I either get a set back or get lazy. lol

steve0914

mike it will never be done! you dont have a t-trim youll always want more! but nice work

Sxynerd

Nah, this car will be done engine wise. Next is to concentrate on the interior and visual mods. After that, this car will be gone for something different.

SVTeeshirt

My set back is my brother has an 81 CJ-5 TAKING UP ALL THE GARAGE SPACE! and hes been to poor to work on it for the last 2 months, hes talking about selling it, i'm seriously posting ads for him because i want it gone so bad. I would just roll it out but its just the tub he doesn't have enough to get the frame back from sandblasting because he is poor, even though its only $150. Tomorrow however hes selling his car so he will be able to get the frame back and pay me the grand he owes me at the same time, which is already pretty much gone... (Machine work, Bore/Hone, Balancing, new bearings.). w00t! for being poor! Fast cars make it all better.

/End Rant.

Chris98Gt

What crank pulley is that?

Sxynerd

Innovators West 10% Overdrive. It increases boost without having to go to a smaller S/C pulley.