Possible Rod Bearing...
#1
Possible Rod Bearing...
Watch the videos below for the sound...
Scenario - I'm getting a ticking / knocking noise from cylinder 8. I originally lost a lot of power, which I thought was due to the tick. I ran the codes and had a misfire in cylinder 4 and 7.
So I replaced all of the plugs and coils. Runs great now. However the tick is still there. Even when I pull the connection for cylinder 8, the tick / knock remains.
I thought if it were a rod bearing the tick / knock would stop when pulling the electrical connector on top of the coil.
The plug has not blown out either. I'm stuck. Any suggestions as to what it could be?
Tick starts at 1:03
http://www.youtube.com/watch?v=r3-5h...os=SmMDU2TqWp8
Ignore the loud power steering... listen for the tick
http://www.youtube.com/watch?v=9Q7f3...os=2XtuqQVkqjI
Scenario - I'm getting a ticking / knocking noise from cylinder 8. I originally lost a lot of power, which I thought was due to the tick. I ran the codes and had a misfire in cylinder 4 and 7.
So I replaced all of the plugs and coils. Runs great now. However the tick is still there. Even when I pull the connection for cylinder 8, the tick / knock remains.
I thought if it were a rod bearing the tick / knock would stop when pulling the electrical connector on top of the coil.
The plug has not blown out either. I'm stuck. Any suggestions as to what it could be?
Tick starts at 1:03
http://www.youtube.com/watch?v=r3-5h...os=SmMDU2TqWp8
Ignore the loud power steering... listen for the tick
http://www.youtube.com/watch?v=9Q7f3...os=2XtuqQVkqjI
Thread
Thread Starter
Forum
Replies
Last Post