JBA LT headers install ?
2nd Gear Member
Joined: Sep 2007
Posts: 300
From: Fredericksburg, Virginia
RE: JBA LT headers install ?
It is absolutely necessary to drop the starter and the bottom of the steering shaft. I just did the installation of JBA shorties using both the JBA LT and Shorty install instructions. I tried to get away with raising the engine to the max and not disconnecting the steering shaft, but no way. Had to remove drivers’ side steering rack bolt (from the top, not the bottom welded on nut), loosening passenger side bolt and sliding the rack forward. Once you drop the shaft against the frame, the headers slide right up where they belong.
Thread Starter
1st Gear Member
Joined: Sep 2007
Posts: 68
From:
RE: JBA LT headers install
ORIGINAL: jay0heavenly
... How about the "Stangmobile" lol...
ORIGINAL: disturbed!
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
... How about the "Stangmobile" lol...
Joined: May 2007
Posts: 13
From:
RE: JBA LT headers install
ORIGINAL: TheRebel
Trans am? All batmobiles except the last two were Thunderbirds
ORIGINAL: disturbed!
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
Joined: May 2007
Posts: 13
From:
RE: JBA LT headers install
ORIGINAL: EXile88GT
sure. but you need to get your windows tinted
ORIGINAL: jay0heavenly
... How about the "Stangmobile" lol...
ORIGINAL: disturbed!
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
you cant call your car the batmobile. lol you dont have a Trans am.
but it does look good
... How about the "Stangmobile" lol...
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
Oct 22, 2015 11:55 PM
Boostaddict
Lethal Performance
2
Sep 8, 2015 09:56 PM
