Can anyone tell me the dimensions of a 2005 (or newer) 4.6 3v motor? I would like to install one into my 1970 mustang. I know I need to swap the front end over to a mustang II front end. I have seen some articles about a 2003/4 mustang cobra motor fitting and its a 4.6 4v so.... a 4.6 3v should fit correct? Thanks everyone.

 

Check out www.fordracingparts.com Motor dimensions are located in the pdf cataloge

 

Should fit, going to be a little work though. These modular 90 degree engines are much wider than the 60 degree push rod motors. Good Luck, sounds like a fun project!