Project no hands **56K Warning Now**
#73
RE: Project no hands
hellion - No I aint running a intercooler yet. I need more money or a good birthday present
Mthd11 - I bought a PK and small VAM for now. Later I'm going to buy a J3 chip and run a large VAM (or MAF) and PE fuel and timing maps.
I may not have it intercooled but by next spring it will be
Mthd11 - I bought a PK and small VAM for now. Later I'm going to buy a J3 chip and run a large VAM (or MAF) and PE fuel and timing maps.
I may not have it intercooled but by next spring it will be
#74
RE: Project no hands
Well I took the crank pully off last night. Damn was it a PITA!!!! (No air compresser so no impact wrench) Had to use a crow bar and a 5ft. pole to get the bolt off and then a puller to get the crank pully off[&:]
Still waiting for the computer and VAM so it looks like the swap wont be done this weekend[&o]
Also I would like to thank MG man for donating a VAM connector to the cause
(If you need any parts mg man, let me know)
Still waiting for the computer and VAM so it looks like the swap wont be done this weekend[&o]
Also I would like to thank MG man for donating a VAM connector to the cause
(If you need any parts mg man, let me know)
#77
RE: Project no hands
no, u wanna use anti seize for the nuts, along with lock washers. you will prolly end up getting a bigger turbo in the future and your gonna want to get it off without damaging the studs or bolts, or flange or whatever.