CarJway

Okay guys, well I got a check engine light on the way home. So I thought I would pull the codes. Well, It's cold and I must of not been paying attention, and hooked up the Jumper wire to what I THOUGHT was the STI plug. I hooked it up to a ORANGE/BLACK wire that looks exactly like the STI plug. It sparked and now my 'Check Engine' light won't come off!!! Looking at the schematics, and I can't figure out what that ORANGE/BLACK wire is!!!

Now that I am trying to pull the codes the RIGHT way, I can not. It is not doing anything!!!

PRO50SC

Damn dude, the wind is blowing like mad outside. You must be freezing your balz off, lol. Have you checked to make sure you didn't blow any fuses?

CarJway

Dude tell me about it!! Well I think I must of fried something on the EEC!!! Since that Black/Orange wire has POWER and I hooked it INTO the Self Test connecter that the JUMPER goes too!!! DAMN IT! Exactly what I need right now! I think I need to find a Mass Air ECU and swap it out. I am pretty sure thats what happened. DAMN IT! Any imput would help me in the Cold Tundra! Any one have a Mass Air EEC they want to sell/trade!!!

-Carlos

PRO50SC

So I take it the car doesn't start now?

88blackgt

could check your eec relay, maybe it went before the ecu if you're lucky

CarJway

It run's and everything... Im about to take it for a test drive. But the Check engine light is Solid on...

Not my week, First my electric fan freezes up last night.... (Fixed it in the cold last night) and now this...

88blackgt

have you tried checking the codes the right way? be careful this time?

CarJway

LOL... thanks 88blackgt...

I did the test the RIGHT way, and NOTHING happens... My test light just stays on constantly...

FiveLiterRiceEater

maybe a short in the cel circuit?

tmajikman

Maybe you could try to pull the negative battery and reset the computer.