93must

With that intake he cant go bigger with the TB. I think he should have put a different intake on it.

r.barn

yes he should have.

a 347 needs a LOT of air in and out to make the power its capable of at
higher rpms.

I bet his power band chokes off just over 5,000 rpm on the dyno too.

93must

He tried to talk me out of my tubular GT-40! haha Not likely!
Oh well it will be $100 in my pocket!

r.barn

even thats not big enough.

he needs a Holley or TrickFlow R intake and 75mm TB

93must

He will figure that out when he dynos it and its not puting the power out that he wants or expects!

ruger311

not going to see the 450crank HP that cam, tb, maf, injs will kill him, he'll be lucky to see 400

88BlueGT

+1 No way he will make 450. He restricted that motor horribly with the rest of that setup. Eveyrthing on his motor except for his shortblock should be be replaced with better parts. Not that his parts arent good... but those things should be on a 302... not a 347 stroker motor.

93must

The heads that are on are the ones that it came with. So it was dynoed with those heads, so he says? I think he will be lucky to get 375! Def the intake MAM and TB are to small. And the injectors are marginal.

FullAuto

Those heads, cam and intake are all poor choices for a 347 and will hold you back. I think it will make 360-380hp to the flywheel.

w8less

i bet this guy is going to be pi$$ed after he spent all of that money on this stroker and doesn't make it over 300rwhp and if it does its barely he needs to change almost everything in his setup