LTnone

I just ordered some solid motor mounts that raise the engine 1/2". Does anyone know if this will have issues clearing the stock hood with the TF upper and lower intake (track heat)? I know the height of the upper and lower is 10.25", wish I had thought of this before ordering[:@]

93must

I dont think you will have any issues as long as you dont have a spacer between the upper and lower intake!

black_pearl_gt

why do you want to raise the engine? wont that make your car tend to roll more? most off the time the mounts lower the engine dont they?

93must

Thats just what those mounts do, its not because they are made to do it. The eurathane is just thicker than the stock mounts by about a half inch!

hellas85stang

solid motor mounts are not good on street,they vibrate motor to much to the point it will be anoying..

vt89gtvert

Sorry to steal the thread, but I am looking at getting new mounts and I have no idea what to look for. 89 vert 5.0 that is my DD. Any suggestions.

AdderMk2

Energy Suspension Poly motor mounts... solids should never even be an option in a street driven car

vt89gtvert

Thanks, but what are you doing up this later adder???

AdderMk2

2:35am... had to urinate....

iceman89gt

definantly shouldnt be a problem especialy if you have a cal hood, i dont know though, if i get bored today i might put my video camera under the hood shut it and see. but you could always take a 1/2 inch stick or something and tape or afix it at the plenum top and close the hood and see i guess.