droptop306

I am seeking some help in picking out the best setup for a 92 mustang convertible. Let me give you some insight on the motor. I have a 306 stroked motor with trickflow heads and 1.6 roller rockers. I have a 75 mm accufab throttle body, 77mm mass air, 30lb injectors and vortech sq2 supercharger. i have a competition tranny and 3:73 gears. Can some one direct me to the best upper and lower intake out there. I would prefer to either have a polished intake or know of somewhere that i can get it done once purchased. You can either send answers here or to my email at droptop306@hotmail.com. thanks alot for any information

ih8chevy

holley systemax
or trick flow track heat
or edelbrock

those are the best three

7upedition

If you have the twisted wedge heads, i'd say go with the street heat upper and lower intake, but the air inlet is 70mm so that TB is a bit too big, you may want to blend those together... good luck which ever you choose

stangman94

go with a trickflow street

w8less

get the holley without a doubt......guys he is supercharged and has heads he is going to need a nice flowing intake. if u decide to go trickflow i wouldn't go any less than the track heat

droptop306

What do you guys think of the new bbk intake? Has anyone used the trick flow intake with this set up? And does any one near MD know where I can have this polished. I am using this on a show car and everything is polished right now. Thanks for info.

droptop306

Hey Jasperstang308 what series trickflow intake is that? Is that the R series that will take either a 75mm or 90mm throttle with the fel pro 1262 gaskets. i see alot of guys having there intake ported to the fel pro 1260's? I just want to get the right one this time so that I can finish this car. I also want to be able to place fuel rails and lines on this intake? thanks

5.0stanger

The 306 isn't stroked, it is bored .030 over. A 331 and a 347 are stroked and bored. Sorry to bust your *****, but I figured I would just let you know.

droptop306

Thanks for correcting me 5.0 stanger, I have had two mustangs and get them confused. This one is .30 over the other is stroked. I am glad that you were able to answer the question though that i posted.

Mustangkiler

Id get a track heat, but if your that big on a polished one get a holley polished intake.