boooosted

Is it really as hard as most people say to put in a gear. I would really like to do it my self and save some money but if its too much of a bitch than I guess Ill takeit some where. Any tips would be appreciated

notch5oh

you need acces to a press if your doing any bearings

PRO50SC

There is a very good article in the May issue of 5.0 magazine. (page 200) You will need some special tools to dial in the rear though. Pick up the mag and have a look. G/L!!

boooosted

thanks. Ill take a look

ddeaton66

Not really hard but detailed and very specific set up that must be done correctly

https://mustangforums.com/m_2535220/tm.htm

thunderjet429

to do it correctly yes.. you need a pinion depth tool, dial indicator, 1/2 inch tourque wrench and inch pound wrench