Mickey Thompson drags
#1
Mickey Thompson drags
Just got my new MT Et's put on today....255/50r16.... what doof you guys find a good psi is for the street. The car is not a daily driver. Thanks.
[IMG]local://upfiles/31432/6DA0B85E19524C53AC0191BD77E03F08.jpg[/IMG]
[IMG]local://upfiles/31432/6DA0B85E19524C53AC0191BD77E03F08.jpg[/IMG]
#5
RE: Mickey Thompson drags
ORIGINAL: AdderMk2
32 psi on the street.... any lower and you will blow them to pieces
drop to 18 when you wanna race
32 psi on the street.... any lower and you will blow them to pieces
drop to 18 when you wanna race
30 on the street, start at 15 at the track then go a little up or down depending on how you hook.
also where are you located in canada?
#8
RE: Mickey Thompson drags
ORIGINAL: Mustangkiler
Could i run mt slics without tubes even if it is recomended?, my rim has bead locks.
Could i run mt slics without tubes even if it is recomended?, my rim has bead locks.
#9
RE: Mickey Thompson drags
thanks, now i just got to hope my new ones dont catch my inner wheel well like the old ones. I was running 28 x 10.5 10 inch tread 11.7 section width , i am hoping 26 x 10 would solve it. 11 section width and 9.6 tread.
#10
RE: Mickey Thompson drags
also where are you located in canada?