anthros

i' am looking for either a roots or twin screw supercharger for the 302 that will allow me to run a carb, and support 5-600 rwhp any ideas or sugestions? I took a look at weind but i have no idea how much hp they support, if you can get a intercooler, where i can get different pullies, how i would route my belt, ect. any help is apriciated.

onesickstang01

man im looking for about the same thing. i found one somewhere but cant remember where right now. ill go through all my stuff and see if i can find it.

DrmZero

if you have a stock bottom end, i wouldnt go much more than 500whp

OneFastEclipse

Look into a Kenny Bell Blowzilla. You can start on lower boost now with your stock stuff, then down the road you could jump to your 600hp goal. http://www.kennebell.net/supercharge...-flowzilla.htm

OnyxCobra

Kenne Bells are run with fuel injection, he's looking for one for a carb. Check out the Weiand superchargers.

jaznasy69

is it a boss block? I dont know about 600 on one of thoes older blocks.. you will waste cash the block will crack ....

raw3836

weiand makes reallll nice stuff for carbs.

Mustangkiler

weiand and dyers are the only two i know for a carb setup and both are roots, and they dont make any kind of intercooler for them.

anthros

ya.......... i was going to lay 5-600 rwhp through a stock block and internals and hope for the best, come on guys iam not that slow, i know it would go boom.

P.S.I.cho

id run with a wiend i was gonna say BDS but im not sure if they dont make anything for a 302, but nothing beats a BDS 671 on a small block, well then again i just looked at their website and they make a blower manifold for a 302, but im pretty sure BDS would be a more expensive route.