BladeX10

Just bought this kit: http://www.streetperformance.com/ART...S/298/8450.jpg at kragen since thats pretty much all they had. They didnt even put any instructions in the kit. For some reason. It feels like something is missing. Sorry for the noob question.. Rather look like a noob and make sure im doing it right then break something. lol

ryan_89_mustang

Do your plug wire boots have the round **** on them so they can have the top piece click into them?

BladeX10

Nope I just have regular wires

ryan_89_mustang

Well it doesn't look like anything is missing but I think you should be able to install the cap and rotor and maybe leave the top piece off. Do the 2 screw holes go all the way through the cap as to let moisture or anything in?

BladeX10

The stock rotor and the msd rotor dont look alike .. Thats the part thats confusing me. How do i install that piece?

I think i can block the screw holes for that top piece with something. Ill have to figure something out

ryan_89_mustang

Well if you can bring it back you may be better off and then just run down to the parts store and get a regular one.

BladeX10

I just put the cap on since the old one was pretty much shot. The rotor didnt look bad at all. So we will see how this works.