I just recently finished rebuilding my motor and added some mods the mods are Trickflow upper/lower intake,bbk 70mm tb, bbk equal length shorties,bbkcatless o/r h pipe, pp stock heads, bbk fuel pressure reg, Fcam, new water pump, flows, pro 5.0 shifter, BBk CAI, 3.73s, 155lph fuel pump, Steeda wires, all new autolite plugs, March underdrives, 76 C&L MAF, 180 degree therm Msd cap and rotar. ( I think thats it) So once i go the engine in after the rebuild and all this stuff, It turns over but isnt starting because its getting no spark. Ive checked the all the spark plugs there gaped correctly, tested the Coil and its fine, checked the ingition and made sure all the wires are correctly placed andthe timing is set to stock. Ive reset the computer also and ran codes, got a few codes but nothing that will cause it not to start up atleast. I dont know what else the problem can be anyone have any ideas?

 

What do you mean it is getting no spark,maybe your module is bad or pickup coil.Are you sure the car is in time,and not out 180 degrees.

 

you need to line up the clinder one with spark plug one bc it sounds like you dont have the distributor in right