grabbem88

the rpms has a plate with two machine screws keeps oil from getting sucked from the valley.
i just never seen that much oil..i still get some no matter what,but not that much.

stanglx2002

i found the problem thank you grabbem88 i didnt have the plat on the bottom of the lower intake i have a new one from edelbrock and i didnt know what it was so i didnt put it on i will take the lower intake off and put the plate on and install everything again thanks for everyones help. i will install the lower intake right this time and not use the front and back gaskets and hope to get a better seal this time to stop that whister sound i have

grabbem88

just send 5 payments of 49.95 to me.
glad to help.

stanglx2002

now i cant get everything back together tom and put my new parts on thurs and sat

i got a Clutch cable kit from MM and also exhaust wrap to keep my engine bay cool

grabbem88

ok i'll just settle with three $3.00 bills.

stanglx2002

i can give you a whole bunch of $thankyou bills

grabbem88

just make me a sticker.

stanglx2002

i will tell you how everything goes im complete it today and hope to get the rest of my parts on this week too

grabbem88

you know i thought about pollishing the inside of mine or extrude honing it.

stanglx2002

me to bc my heads are polished already so i thought about polishing the intake and im C&L inlet tube too. also im going to polish the outside of the intake to have the only polished Edelbrock intake it will be different