HP with build?
#1
HP with build?
GT-40s iron professionally ported
TF Street Heat Intake
Stock Cam with 1.7 scorpion rrs
later i want to upgrade to a Crower 15511 cam
full boltons... (LTs, Prochamber, Flows, 75mm TB, U/D pulleys, CAI, AC & Smog delete, Full Tune up (cap rotor plugs wires, ECT ACT) EGR delete, Aluminum Drive Shaft, Aluminum Flywheel)
any esitmates? only thing that will not be on the car when i get the H/c/i is the flywheel im waiting a bit cuz my clutch is still pretty new
TF Street Heat Intake
Stock Cam with 1.7 scorpion rrs
later i want to upgrade to a Crower 15511 cam
full boltons... (LTs, Prochamber, Flows, 75mm TB, U/D pulleys, CAI, AC & Smog delete, Full Tune up (cap rotor plugs wires, ECT ACT) EGR delete, Aluminum Drive Shaft, Aluminum Flywheel)
any esitmates? only thing that will not be on the car when i get the H/c/i is the flywheel im waiting a bit cuz my clutch is still pretty new
#3
RE: HP with build?
with the stock cam 240-250rwhp
and with the cam i dont know exact specs but it could make around 275rwhp when done and then get some kind of tune atleast an a/f ratio dyno session[8D]
and with the cam i dont know exact specs but it could make around 275rwhp when done and then get some kind of tune atleast an a/f ratio dyno session[8D]
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM