Fan controller override questions. - MustangForums.com

5.0L General Discussion This section is for non-tech specific information pertaining to 5.0L Mustangs.

Fan controller override questions.

Reply

 
 
 
Old 10-12-2018, 04:18 PM
  #1  
1988MUSKRAT
2nd Gear Member
Thread Starter
 
1988MUSKRAT's Avatar
 
Join Date: Apr 2008
Location: Hagerstown Md
Posts: 185
Default Fan controller override questions.

Im going to be doing a electric fan conversion soon. I have the mishimoto fan setup and just ordered the fan controller .I plan on putting the sensor in the water neck and I want to hook up the override switch. The po took of the ac compressor off and the power steering pump is in its place now. Can you use the ac compressor harness as a override switch by turning the ac control on? Where does the harness for the compressor come from the main harness?
1988MUSKRAT is offline  
Reply With Quote
Old 10-12-2018, 10:24 PM
  #2  
imp
2nd Gear Member
 
imp's Avatar
 
Join Date: Jul 2017
Location: AZ
Posts: 410
Default

Originally Posted by 1988MUSKRAT View Post
Im going to be doing a electric fan conversion soon. I have the mishimoto fan setup and just ordered the fan controller .I plan on putting the sensor in the water neck and I want to hook up the override switch. The po took of the ac compressor off and the power steering pump is in its place now. Can you use the ac compressor harness as a override switch by turning the ac control on? Where does the harness for the compressor come from the main harness?
Sure, but it might not turn on the fan. Depends on what entity turns fan on in the first place. Also if it DOES turn on the fan, do you want the AC compressor running every time you do it, even during cold weather? imp
imp is offline  
Reply With Quote
Old 10-13-2018, 03:18 AM
  #3  
08'MustangDude
4th Gear Member
 
Join Date: Jan 2018
Location: Pennsylvania
Posts: 1,468
Default

The po took of the ac compressor off and the power steering pump is in its place now.
I read that as, someone removed the compressor.

No, you cannot use the A/C harness for the compressor because now, since there is no
compressor, that means no refrigerant in the system, and even with a compressor with
no refrigerant, it would not turn on.

You can ALWAYS wire a manual switch inside the car to over-ride the fan, and turn it
on. If your new fan is going to have a control relay, then you wire a switch from inside
to trigger the relay coil.

Diode isolate the trigger for the relay from the car source.
Wire the bypass switch tn the coil, in front of the diode.

Last edited by 08'MustangDude; 10-13-2018 at 03:20 AM.
08'MustangDude is online now  
Reply With Quote
Old 10-13-2018, 04:57 AM
  #4  
08'MustangDude
4th Gear Member
 
Join Date: Jan 2018
Location: Pennsylvania
Posts: 1,468
Default



Just a BASIC diagram, there will be a fuse in there for the fan's power... This just shows how
to hook up a bypass witch to the same fan relay the controller would use.
08'MustangDude is online now  
Reply With Quote
Old 10-13-2018, 05:51 PM
  #5  
imp
2nd Gear Member
 
imp's Avatar
 
Join Date: Jul 2017
Location: AZ
Posts: 410
Default

Originally Posted by 08'MustangDude View Post


Just a BASIC diagram, there will be a fuse in there for the fan's power... This just shows how
to hook up a bypass witch to the same fan relay the controller would use.
Very Nice! Now, what if it's a multiple-speed fan?
Just bein' facetious! imp
imp is offline  
Reply With Quote
Old Yesterday, 12:59 AM
  #6  
08'MustangDude
4th Gear Member
 
Join Date: Jan 2018
Location: Pennsylvania
Posts: 1,468
Default

Then pick which side you want to bypass, hi or low.
08'MustangDude is online now  
Reply With Quote
Old Yesterday, 01:56 PM
  #7  
1988MUSKRAT
2nd Gear Member
Thread Starter
 
1988MUSKRAT's Avatar
 
Join Date: Apr 2008
Location: Hagerstown Md
Posts: 185
Default Thanks.

Just wanted to use what was already there but looks like ill have to install a switch somewhere. The fan contoller comes with a green wire that I can use as the override will it still need a fuse?

Last edited by 1988MUSKRAT; Yesterday at 01:59 PM.
1988MUSKRAT is offline  
Reply With Quote
Old Today, 01:08 AM
  #8  
08'MustangDude
4th Gear Member
 
Join Date: Jan 2018
Location: Pennsylvania
Posts: 1,468
Default

IF you want a manual override, of course you will need to add a switch.
You can put like, a 1A fuse on the wire you're going to energize the coil manually with.
08'MustangDude is online now  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mustangman_1969
5.0L (1979-1995) Mustang
14
10-12-2011 04:15 PM
itscalledred
4.0L V6 Technical Discussions
1
10-19-2008 02:25 PM
john721
Classic Mustangs (Tech)
14
08-14-2007 11:57 PM
Dallas
5.0L (1979-1995) Mustang
2
07-15-2007 10:14 AM
djdalfaro
4.6L (1996-2004 Modular) Mustang
4
06-21-2006 12:22 PM

Forum Jump

Thread Tools
Search this Thread
Advertising
Featured Sponsors
Vendor Directory