I have searched I cant find a removal guide for the 2010 base stereo and bezel. I want to install the PAC ipod interface but I need to get behind the radio. Any help is appreciated. Thanks

 

If its anything like the 2005-09 it doesnt pop out. There are screws.

Not sure if this will work on your 2010.

http://www.youtube.com/watch?v=YXFk6GtzGi0

 

I dont think its like that thanks for trying though. But the video did help a bit. I pulled up the back of my center console behind the shifter and it popped. Im gonna try to completely disassemble this weekend.

 

just lift up the center console from around the shifter unplug the harness for the trunk release, hazards, and stability control buttons and set it to the side then remove the 2 8mm screw from the bottom of the bezel and pull on the bezel. its very easy & a hell of alot easier than the 05-09s

 

x2 that sums it up

 

I'm still having trouble.. Where are the screw to remove the consol?

 

I think it is the same as the 2011-13's, look at my writeup Here might help.