5.0 GT Motor Build - Machine Shop?
#1
5.0 GT Motor Build - Machine Shop?
Hey guys,
I'm a complete newbie when it comes to the Mustang here in Orange County, CA but have been around the block with a few other import cars.
I'm looking to build a 2013 5.0 GT to run 800-1000HP and hopefully high 9's.
I'd like your guys advice on where to get the bottom end built with reduced compression pistons and forged rotating assembly. I can pull the motor myself but want to find a good machine shop.
Also any suggestions as to FI recommendations to run 9's?
THanks!
I'm a complete newbie when it comes to the Mustang here in Orange County, CA but have been around the block with a few other import cars.
I'm looking to build a 2013 5.0 GT to run 800-1000HP and hopefully high 9's.
I'd like your guys advice on where to get the bottom end built with reduced compression pistons and forged rotating assembly. I can pull the motor myself but want to find a good machine shop.
Also any suggestions as to FI recommendations to run 9's?
THanks!
#2
Hey guys,
I'm a complete newbie when it comes to the Mustang here in Orange County, CA but have been around the block with a few other import cars.
I'm looking to build a 2013 5.0 GT to run 800-1000HP and hopefully high 9's.
I'd like your guys advice on where to get the bottom end built with reduced compression pistons and forged rotating assembly. I can pull the motor myself but want to find a good machine shop.
Also any suggestions as to FI recommendations to run 9's?
THanks!
I'm a complete newbie when it comes to the Mustang here in Orange County, CA but have been around the block with a few other import cars.
I'm looking to build a 2013 5.0 GT to run 800-1000HP and hopefully high 9's.
I'd like your guys advice on where to get the bottom end built with reduced compression pistons and forged rotating assembly. I can pull the motor myself but want to find a good machine shop.
Also any suggestions as to FI recommendations to run 9's?
THanks!
#4
I would absolutely do a shortblock from MMR out west. They can hook you up and their prices are reasonable. I'm partial to ProCharger, but pretty much any power adder will get you there. However, the UPR-spec Procharger is STOUT!
Thread
Thread Starter
Forum
Replies
Last Post