CAROLINA CHAT
4th Gear Member
Joined: Aug 2012
Posts: 1,413
From: Close Enough
Great numbers Jeff. Glad it went as well as you hoped and looking forward to checking it out in person. Are you still going to change the MBRP's?
Alan, Hope the gear install went well. I'm still debating on what I want to do. MBRP's or 3:73's first..then the Procharger
Alan, Hope the gear install went well. I'm still debating on what I want to do. MBRP's or 3:73's first..then the Procharger
6th Gear Member
Joined: Aug 2011
Posts: 7,233
From: Thomasville, NC Where we beat headers into submission!!
I am going to stick with the MBRP's. They sounded pretty darn good on the dyno yesterday.
5th Gear Member
Joined: Dec 2010
Posts: 3,114
From: South Carolina
I have to measure the pulley that is on there. If it's 3-1/2 then I am going to have to do longtubes since a larger pulley will not fit under the stock hood according to Kenne Bell.
Of course it would probably cost the same to do the larger pulley and a nice new cowl hood...hmmm
Of course it would probably cost the same to do the larger pulley and a nice new cowl hood...hmmm
6th Gear Member
Joined: Aug 2011
Posts: 7,233
From: Thomasville, NC Where we beat headers into submission!!
6th Gear Member
Joined: Aug 2011
Posts: 7,233
From: Thomasville, NC Where we beat headers into submission!!
6th Gear Member
Joined: Aug 2011
Posts: 5,287
From: South Carolina, Axle swap anyone?
O well in that case I'm good to go! Wait I don't want gears....
5th Gear Member
Joined: Apr 2011
Posts: 3,578
From: Charlotte NC
Just a quick thanks to Jeff,Alan,Kevin and John. Dad's procedure went well today and things are looking good so far.
I tried to contact Dana and Heather today.I Left a voice mail but didn't hear anything from them. I'll try again tomorrow.
I tried to contact Dana and Heather today.I Left a voice mail but didn't hear anything from them. I'll try again tomorrow.
