What are you working on?
#5021
6th Gear Member
With the BMR K-Member there is tons of room and the headers are clear. I have to take it for an alignment so I'll have them check.
#5023
6th Gear Member
Join Date: Aug 2011
Location: Thomasville, NC Where we beat headers into submission!!
Posts: 7,233
#5026
6th Gear Member
Join Date: Aug 2011
Location: Thomasville, NC Where we beat headers into submission!!
Posts: 7,233
I told JJ that he was way more patient than I would have been. It was one thing when it was sitting at his house and another story all together when it was sitting at the shop for a month.
#5028
6th Gear Member
Thanks guys....we talked through it. Boils down to I'm depending on him to get the car done and he was depending on his Ford contact to make time to do some side work. Then last week his shop was at their annual coyote training. Still have a couple a issues to work through....
DTC code P0315 - Crank shaft position not recognized. I have to get someone with a Pro Cal to give the car a relearn session.
DTC code P1289 - Yep, this code is back. Neither code give a CEL, but I want them fixed.
As for the HP....Unreal! 631 and 514....Love it!
DTC code P0315 - Crank shaft position not recognized. I have to get someone with a Pro Cal to give the car a relearn session.
DTC code P1289 - Yep, this code is back. Neither code give a CEL, but I want them fixed.
As for the HP....Unreal! 631 and 514....Love it!