KRC PS tank
#1
KRC PS tank
This is a pic of a KRC power steering reservoir/tank. The AN10 outlet is made of about 2mm to 3mm aluminum
and poorly designed. If the line is tightened the sealing surface will just push up making it very difficult to seal
and it will get worse the more times the pipe is reconnected. Their pump on the other hand seems well built.
I notice that TCP and MD no longer supply this tank and use the Billet Specialties unit, which I replaced this
unit with. The BS unit is much more solidly built.
Jav
and poorly designed. If the line is tightened the sealing surface will just push up making it very difficult to seal
and it will get worse the more times the pipe is reconnected. Their pump on the other hand seems well built.
I notice that TCP and MD no longer supply this tank and use the Billet Specialties unit, which I replaced this
unit with. The BS unit is much more solidly built.
Jav
#4
RE: KRC PS tank
ORIGINAL: andrewmp6
You could clean up that lip with a metal file and a little time going slow or just ebay it.
You could clean up that lip with a metal file and a little time going slow or just ebay it.
But seriously, that would not fix the issue, the sealing surface will just push up further
as the whole neck is too thin.
Jav
Thread
Thread Starter
Forum
Replies
Last Post
mrappe
V6 (1994-2004) Mustangs
0
09-26-2015 10:16 AM