I hate the grey gasket used to seal the back up lights to the rear valence. Does anyone know if the Black gasket for a 65-66 would work with 67 back up lights?

Thanks

 

I don't know, but I agree. I don't care for the gray ones much either. Its not that bad, but the black would look better.

I think they only cost a couple bucks. I say try it and see, unless someone chimes in and says they won't work.

I'll try to get a decent measurement of the diameter of my backup lights and you can compare that to yours.

 

If you have a mustang parts supplier that you use, call them and ask. I've found that they will give you any info you need, cause you just might buy from them.

 

Thanks for the help, since Im driving out to NPD tomorrow so I will add it to my list since its only $2.50. I will let you guys know.

 

I just measured mine and they are about 4 inches diameter to the outer edge. It is possible that the chrome housing on one or the other is thicker/thinner so the gasket may not work because of that.

 

Why not paint or use a Sharpie to make the grey one black?

 

Paint flakes off on rubber. I never thought of the sharpie. I will use that as a last resort. I dont want the sun turning it brown